Table of Contents
Advertisement
6
DUALWATCH/TRI-WATCH
■ Description
Dualwatch monitors Channel 16 while you are receiving
another channel; tri-watch monitors Channel 16 and the call
channel while receiving another channel.
DUALWATCH/TRI-WATCH SIMULATION
Dualwatch
• If a signal is received on Channel 16, dualwatch/tri-watch
pauses on Channel 16 until the signal disappears.
• If a signal is received on the call channel during tri-watch,
tri-watch becomes dualwatch until the signal disappears.
• To transmit on the selected channel during dualwatch/tri-
watch, push and hold [PTT].
14
Call channel
Tri-watch
■ Operation
q Select the desired operating channel.
w Push
for 1 sec. to start dualwatch or tri-watch
[SCAN•
]
DUAL
(depending on the SET mode setting).
• "DUAL" blinks during dualwatch; "TRI" blinks during tri-watch.
• A beep tone sounds when a signal is received on Channel 16.
• Tri-watch becomes dualwatch when receiving a signal on the
call channel.
e To cancel dualwatch/tri-watch, push
[Example]: Operating tri-watch on INT channel 07.
Push
for 1 sec.
again.
[SCAN•
]
DUAL
Tri-watch starts.
Signal is received
on the call channel.
Signal is received
on
Channel
16
takes priority.
Tri-watch resumes
after
the
signal
disappears.
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the IC-M90 and is the answer not in the manual?
Questions and answers