Removable Front Panel - Gree GA Series Product Data

PRODUCT FEATURES AND BENEFITS (GA Series)
APPLICATIONS
Whether you are designing a new structure or
NO- -RUST WALL SLEEVE
replacing packaged terminal air conditioning units in
AND FRONT PANEL
an existing building, Gree GA Series will meet your
needs.
The indoor front panel and polymer wall sleeve use
•
nonmetallic compounds that never rust or corrode, do Hotels and motels
•
not support combustion, and do not give off toxic
Nursing homes and assisted living care
fumes. The weather-resistant
centers
requirements of Underwriters Laboratories and resists
•
Offices
damage caused by impact and scratching.
•
Apartments
Insulated polymer wall sleeves combine all of the
•
Single- -family dwellings
above features with factory-installed insulation. The
•
Home conversions and residential add- -ons
insulation helps to reduce heat loss, save energy,
provide better sound absorption, and reduce the risk
NEW CONSTRUCTION
of sleeve sweating.
Grees's metal wall sleeves are available in a variety
The Gree GA series Packaged Terminal Air
of sizes for most standard and deep wall applications.
Conditioning (PTAC) unit is designed to meet the
All metal wall sleeves come with factory-installed
needs of the architect, engineer, and contractor. For
insulation, designed to minimize heat loss and reduce
unit installation, Gree's expert support network will
outdoor noise transmissions into the room.
assist in all applicable aspects of the construction
project, from preparing a budget to start-up.
ADVANTAGES FOR NEW
CONSTRUCTION
Design Flexibility for the Architect/Engineer
•
Whisper- -quiet performance, indoors and out

REMOVABLE FRONT PANEL

•
No bulky duct system
•
No separate equipment room
The louvered front panel fits firmly onto the chassis
•
and features easy removal for service. It provides
No water towers or additional cooling
front air intake to enhance performance and quiet
equipment
operation. •
No complex match- -up of different HVAC
components
•
Less sensitivity to building orientation (sun,
wind, shade)
•
Optional architectural grille to permit custom
exterior appearance
Initial Cost Savings for the Building Owner
•
No expensive component HVAC system
purchase
TWO- -PIECE LIFETIME INDOOR
•
No equipment
FILTER
engineering staff
•
Two- -part delivery to minimize on- -site
Two- -piece removable filters easily slide in and out
damage
from the front of the PTAC unit and are
•
Weather- -protected wall sleeve that goes in
interchangeable. The front panel does not need to be
place during construction; chassis that slides
removed to access or change the filters. The filters are
in place after construction
washable and permanent.
•
No seasonal changeover required for cooling
or heating - - units are self- -contained comfort
systems
feature exceeds
room or maintenance
Lower Operating Costs and Reliable Comfort
for The Occupant
•
Heat pump models offer substantial savings
over models with conventional electric
resistance heaters
•
Individual units allow tenants to choose the
degree of comfort and operating economy.
•
Rapid servicing reduces downtime: complete
chassis can be replaced in minutes without
disrupting other occupants.
•
Each unit operates independently of other
units in the building. No dependency by
Standard Wall Sleeve (Polymer)
building on central HVAC system.
RETROFIT/REPLACEMENT
If you are replacing a unit in an existing wall sleeve,
your options include:
•
Replace the existing wall sleeve with the
the polymer wall sleeve. See accessory sleeve
section for selecting the correct sleeve for
your application.
NOTE: in most cases, when replacing the
Amounts in ( ) = mm
wall sleeve, the exterior grille must also be
Standard and Deep Wall Sleeve (Metal)
replaced.
•
Use an existing sleeve and exterior grille. The
Gree GA series PTAC will fit into:
The following major competitors' wall
—
sleeves/grilles: Carrier, GE, Amana,
Trane, Friedrich and Bryant, and NO
accessory retrofit kit is required.
— Friedrich T series and ZoneAire wall
sleeves, with a required wall sleeve
extension (see accessory Friedrich
Retrofit Wall Sleeve Adapter).
Front Panel
Two -- Piece Indoor Filter
8
4
42"
(1067 mm)
16"
(406 mm)
14-7/8"
(378 mm)
A07633
42 in
(1067)
16 in
(406)
Available in:
14-3/4 in. (375),
18 in. (457),
24 in. (610),
26 in. (660),
28 in. (711)
A07381
A07381
2 Air filters
A07381