Gree GA Series Product Data page 44

APPLICATIONS
3.0 DELIVERY, STORAGE, AND
HANDLING
Whether you are designing a new structure or
The packaging of the chassis shall be sufficient to
replacing packaged terminal air conditioning units in
protect the chassis from damage during shipment via
an existing building, Gree GA Series will meet your
an enclosed truck. Chassis must also be able to
needs.
withstand an impact force of 8 g's and a random
•
Hotels and motels
continuous force of 1g, during shipping.
•
Nursing homes and assisted living care
Chassis, wall sleeves, and grilles shall be shipped in
centers
separate cartons. Universal handling instructions
•
Offices
shall be defined and visible on the carton, from front,
•
back and sides.
Apartments
•
Single- -family dwellings
•
Home conversions and residential add- -ons
NEW CONSTRUCTION
NOTES: The Gree GA series Packaged Terminal Air
Conditioning (PTAC) unit is designed to meet the
________________________________________________________________________________________
needs of the architect, engineer, and contractor. For
unit installation, Gree's expert support network will
________________________________________________________________________________________
assist in all applicable aspects of the construction
project, from preparing a budget to start-up.
________________________________________________________________________________________
ADVANTAGES FOR NEW
CONSTRUCTION
________________________________________________________________________________________
Design Flexibility for the Architect/Engineer
•
Whisper- -quiet performance, indoors and out
________________________________________________________________________________________
•
No bulky duct system
•
No separate equipment room
________________________________________________________________________________________
•
No water towers or additional cooling
equipment
________________________________________________________________________________________
•
No complex match- -up of different HVAC
components
________________________________________________________________________________________
•
Less sensitivity to building orientation (sun,
wind, shade)
________________________________________________________________________________________
•
Optional architectural grille to permit custom
exterior appearance
________________________________________________________________________________________
Initial Cost Savings for the Building Owner
•
No expensive component HVAC system
________________________________________________________________________________________
purchase
•
No equipment
________________________________________________________________________________________
engineering staff
•
Two- -part delivery to minimize on- -site
damage
________________________________________________________________________________________
•
Weather- -protected wall sleeve that goes in
place during construction; chassis that slides
in place after construction
•
No seasonal changeover required for cooling
or heating - - units are self- -contained comfort
systems
Copyright 2010 Gree Electric Appliance Inc.
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
room or maintenance
Printed in U.S.A.
Lower Operating Costs and Reliable Comfort
for The Occupant
Chassis shall be
•
temperatures from - -40 ˚ F to 155 ˚ F (- -40 ˚ C to
Heat pump models offer substantial savings
68.3 ˚ C), at 5 to 95 percent RH, non- -condensing,
over models with conventional electric
during shipment and storage, without component
resistance heaters
failure. •
Individual units allow tenants to choose the
degree of comfort and operating economy.
•
Rapid servicing reduces downtime: complete
chassis can be replaced in minutes without
disrupting other occupants.
•
Each unit operates independently of other
units in the building. No dependency by
building on central HVAC system.
RETROFIT/REPLACEMENT
If you are replacing a unit in an existing wall sleeve,
your options include:
•
Replace the existing wall sleeve with the
the polymer wall sleeve. See accessory sleeve
section for selecting the correct sleeve for
your application.
NOTE: in most cases, when replacing the
wall sleeve, the exterior grille must also be
replaced.
•
Use an existing sleeve and exterior grille. The
Gree GA series PTAC will fit into:
The following major competitors' wall
—
sleeves/grilles: Carrier, GE, Amana,
Trane, Friedrich and Bryant, and NO
accessory retrofit kit is required.
— Friedrich T series and ZoneAire wall
sleeves, with a required wall sleeve
extension (see accessory Friedrich
Retrofit Wall Sleeve Adapter).
Edition Date: 6/10
44
4
capable of withstanding
Catalog No. PTAC-GA-1PD