Programmable Thermostat - Gree GA Series Product Data

Packaged terminal air conditioner / heat pump 7,000-15,000 btuh
Table of Contents

Advertisement

APPLICATIONS
FIELD- -INSTALLED ACCESSORIES (CONT.)
THERMOSTATS
Whether you are designing a new structure or
Gree's full line of wall thermostats are designed to enhance every PTAC application. The TopTech Comfort Series
replacing packaged terminal air conditioning units in
of thermostats consists of programmable and non-programmable air conditioner and heat pump controls. These
an existing building, Gree GA Series will meet your
units feature non-mercury, non-lead based electronic controls built into a subtle, 1.2 inch (30.5 mm) slim plastic
needs.
enclosure. Wall thermostats are simple and easy to use. Wall thermostats provide better temperature and humidity
Hotels and motels
control as they can be placed in an optimal position in the room. All Top Tech 400 series thermostats features
Nursing homes and assisted living care
Temperature Range Limiting to help prevent wasted energy and optimize energy savings opportunities. See page
centers
30 for thermostat wiring instructions.
Offices
In addition, multiple GA series PTACs can be controlled by a single wall thermostat. See page 40 for wiring
Apartments
multiple PTAC units to one thermostat.
Single- -family dwellings
Home conversions and residential add- -ons
Non- - Programmable Thermostat
NEW CONSTRUCTION
Part No.: TT-N-411 (Heat / Cool Models)
Part No.: TT-N-421 (Heat Pump Models)
The Gree GA series Packaged Terminal Air
This low- -voltage, easy- -to- -use non- -programmable
Conditioning (PTAC) unit is designed to meet the
thermostat provides maximum guest comfort.
needs of the architect, engineer, and contractor. For
Dual Powered – Hardwired or Battery
unit installation, Gree's expert support network will
Large Display with Bright Blue Backlight
assist in all applicable aspects of the construction
Adjustable Temperature Set Point Limits
project, from preparing a budget to start-up.
Non-Volatile Memory Retains User Settings
ADVANTAGES FOR NEW
Easy Access Front Battery Door
CONSTRUCTION
Compressor Short Cycle Protection
Design Flexibility for the Architect/Engineer
Separate Heating and Cooling Set Points
ESD Guard™ Electronic Circuitry
Whisper- -quiet performance, indoors and out
Display Degree F or C Switch
No bulky duct system
Mount to Horizontal Box
No separate equipment room
Adjustable Temperature Differential
No water towers or additional cooling
equipment
Digital Programmable Thermostat
No complex match- -up of different HVAC
components
Part No.: TT-P-411 (Heat / Cool Models)
Less sensitivity to building orientation (sun,
Part No.: TT-P-421 (Heat Pump Models)
wind, shade)
This micro computer controlled, 7- -day
Optional architectural grille to permit custom
programmable wall thermostat has enhanced features
exterior appearance
for both heat pumps and heating/cooling units.
Initial Cost Savings for the Building Owner
The
programmable
non- -programmable features plus the following:
No expensive component HVAC system
5-2 Day Separate Weekday / Weekend
purchase
Programming
No
equipment
Adaptive Recovery Mode (ARM™)
engineering staff
Separate Heating and Cooling Set Point
Two- -part delivery to minimize on- -site
Program Times
damage
Temporary Program Override
Weather- -protected wall sleeve that goes in
Programmable Extended Hold Mode
place during construction; chassis that slides
Meets California Title 24 Guidelines
in place after construction
No seasonal changeover required for cooling
or heating - - units are self- -contained comfort
systems
model
includes
the
room
or
maintenance
Lower Operating Costs and Reliable Comfort
for The Occupant
Heat pump models offer substantial savings
over models with conventional electric
resistance heaters
Individual units allow tenants to choose the
degree of comfort and operating economy.
Rapid servicing reduces downtime: complete
chassis can be replaced in minutes without
disrupting other occupants.
Each unit operates independently of other
units in the building. No dependency by
building on central HVAC system.
RETROFIT/REPLACEMENT
If you are replacing a unit in an existing wall sleeve,
your options include:
Replace the existing wall sleeve with the
the polymer wall sleeve. See accessory sleeve
section for selecting the correct sleeve for
your application.
NOTE: in most cases, when replacing the
Non -- Programmable Thermostat
wall sleeve, the exterior grille must also be
replaced.
Use an existing sleeve and exterior grille. The
Gree GA series PTAC will fit into:
The following major competitors' wall
sleeves/grilles: Carrier, GE, Amana,
Trane, Friedrich and Bryant, and NO
accessory retrofit kit is required.
— Friedrich T series and ZoneAire wall
sleeves, with a required wall sleeve
extension (see accessory Friedrich
Retrofit Wall Sleeve Adapter).

Programmable Thermostat

22
4

Advertisement

Table of Contents
loading

Table of Contents