Blackmagicdesign Teranex 2D Processor Installation And Operation Manual page 83

Using your Favourite Editing Software
83
Batch Capture
If you wish to batch capture using RS-422 deck control, select the clips you wish to capture by drag-selecting
or shift-clicking each clip. Then choose: File > Batch Capture [F6]. To set handles on the clips, enable the
option to Capture with handles and type the number of additional frames you require at the start and end
of each clip.
Export to Tape
To export to tape via RS-422 deck control, select the sequence you require and then choose File >
Export > Tape
Insert editing requires unbroken timecode over the full length of the project which is to be laid to tape.
In assemble mode the tape needs only to be "blacked" until a point just beyond the start time of the
project. As assemble editing erases the tape ahead of the record heads, it should not be used where other
projects already exist on the tape after the out point of your edit.
When editing to tape, the software waits at the first frame of your project for the deck to drop into record
at the predetermined timecode. Should you find that either the first frame of your program is repeated or
lost, during the edit to tape procedure, you will need to adjust the playback offset to bring the deck and
computer in sync. You should only need to do this once with any combination of deck and computer and
the correct setting will be retained.
Export to Tape
Now, simply enter the desired in point and offsets if required, and click OK.