Blackmagicdesign Teranex 2D Processor Installation And Operation Manual page 61

Understanding the LCD Menus
61
In Input Regen mode, drop frame and non drop frame modes are both supported in 23.98, 29.97 and 59.94
frame rates. However, in a conversion where the source timecode is drop frame and the video output format
does not support drop frame timecode, (e.g. 50Hz or 60Hz integer frame rates), the output timecode will
automatically be converted to non drop frame.
Closed
Video Main Menu Setup Ancillary Data
Caption
Noise
Timecode
Reduction
Ancillary Video
Data Index
Back
Main Menu Ancillary Data
1 2
Generate Mode
The timecode generator will generate free running output timecode appropriate for the selected
output format, even if no timecode is present on your video input signal. The Set Timecode menu seen
is dependent on the choice you made in the Start Source menu, "Input" or "Start Value."
If the Start Source menu is set to "Input," the Set Timecode menu will show "Input" as the Start Value
for the generator (see below). When you press the Start button, the generator will capture the current
input timecode value and use that value to start outputting free running timecode. If no timecode is
present on your input video source, the generator will begin counting at 00:00:00:00.
Closed
Video Main Menu Setup Ancillary Data
Caption
Noise
Timecode
Reduction
Ancillary Video
Data Index
Back
Main Menu Ancillary Data
1 2
Menu number 4 above will be seen when the Set Timecode button is pressed and the Start Source menu is set to Input.
Mode
Timecode
Setup
Select
Off
Set Start
Timecode Source
Input
Input Regen
Prev Next
Generate
Back Start Back
Jam Sync
Timecode / Mode Select /
3
Input Regen
Mode
Timecode Setup Mode
Select
Off
Set Start Set
Timecode Source Timecode
Input
Input Regen
Prev Next Prev
Generate
Back Start Back Start
Jam Sync
Timecode Mode Select / Generate /
3 4
Set Timecode
Timecode Setup
Start Value
Start
Input
Source
Next
Back