Capturing And Playing Back Video - Blackmagicdesign Teranex 2D Processor Installation And Operation Manual

Capturing and Playing Back Video

23
Click the "Capture" button to commence recording
Video Playback test using Blackmagic Media Express
Import a test clip in to Media Express. If you see a message that the selected video format is not compatible
with the current project, click "Don't save" to discard the current project and create a new project for
the test clip.
Double click the test clip and you should see the video on the monitor connected to the output of your
Teranex 2D Processor. Audio output can also be monitored.
Video Capture test using Blackmagic Media Express
‚ Go to Media Express>Preferences on Mac OS X.
‚ Select a project format which matches your converted video output rather than the source video.
‚ Choose a capture file format.
‚ Set the storage location for your captured video and audio and choose whether to stop capture
or playback if dropped frames are detected. Choose a compressed capture file format so you can
capture to any disk.
‚ Close the Preferences and click on the Log and Capture tab. You should immediately see your
converted video source in the video preview pane of Media Express.
‚ Click Capture to perform the capture test. Click Capture again to finish the test. Double click on
the captured clip in the Media List to play it back on screen and on the outputs of your Teranex 2D
Processor hardware.
For further information on Blackmagic Design Media Express refer to detailed section in this manual.