Table of Contents
Advertisement
HDD SET SETTING
Main menu 2
<MAIN MENU 2>
1.DISPLAY SET/VIDEO LOSS SET ->
2.RS-232C/RS-485 SET
->
3.BUZZER SET
->
4.SECURITY LOCK SET
->
5.NETWORK SET
->
6.HDD SET
->
7.POWER FAILURE/USED TIME
->
TO MAIN MENU 1
->
MOVE LINES WITH JOG. SELECT WITH SHUTTLE
HDD SET setting
To display hard disk capacity in DISK1 (on board) and DISK2 (for
addition)
Note: Before adding a hard disk, it is important to backup recorded
images on a media such as a CompactFlash card.
1
Press the MENU button twice to display the MAIN MENU 2
screen.
The cursor moves to DISPLAY SET/VIDEO LOSS SET.
MENU
2
Use the jog dial to move the cursor to the HDD SET settings,
and then turn the shuttle dial clockwise.
The HDD SET sub-menu appears, and the cursor moves to DISK
INITIALIZE.
3
Turn the shuttle dial clockwise.
A WARNING screen appears and then "NO" flashes.
English
Sub-menus
<HDD SET>
DISK1
:
80GB
DISK2
: ---GB
DISK INITIALIZE
->
CAUTION : ALL RECORDING WILL BE ERASED!
MIRRORING
: OFF
PLAYBACK DRIVE
: ¤¤¤
CAUTION : RECORDING SPEED WILL BE
LIMITED BY MIRRORING!
<HDD SET>
DISK1
:
80GB
DISK2
: ---GB
DISK INITIALIZE
->
CAUTION : ALL RECORDING WILL BE ERASED!
MIRRORING
: OFF
PLAYBACK DRIVE
: ***
CAUTION : RECORDING SPEED WILL BE
LIMITED BY MIRRORING!
<WARNING>
THIS CHANGE WILL INITIALIZE THE DISK.
ALL RECORDING WILL BE ERASED.
ARE YOU SURE ?
NO
CHANGE LINES WITH JOG. SELECT WITH SHUTTLE
Initializes hard disk.
Records mirroring.
Sets the hard disk reading.
4
Use the jog dial to select YES, and then turn the shuttle dial.
The "HDD INITIALIZING!" screen appear and the hard disk is
initialized. Then the display is returned to the HDD SET screen.
5
Press the EXIT/OSD button.
The display returns to the normal screen.
EXIT/OSD
Adding a hard disk
Consult your dealer about adding a hard disk. In the case of an
addition, use an additional hard disk unit (sold separately).
If adding another hard disk, be sure to initialize the hard disks. When
this is done, both hard disks will be initialized, so that any existing data
on the original hard disk will be cleared.
Reference: HDD SET screen
•
MIRRORING: When a hard disk is added, it is possible to record
the same image on two hard disks. This means that even if an
image write error occurs you will be able to read from an area
where there is no write error. Note that if mirroring is specified, the
upper limit of recording speed will be limited.
•
PLAYBACK DRIVE: After MIRRORING has been set, you will be
able to specify which of the two hard disks is to be used for reading
the recorded image.
With mirroring setting, if an error has occurred in the playback
image, switch from the hard disk in current use (DISK1) to (DISK2).
67
HDD INITIALIZING !
Advertisement
Table of Contents
