Table of Contents
Advertisement
Timer recording starts when the timer setting time is
4
reached.
"a" appears in the operating display and the images being monitored are
recorded in the normal recording area. Recording onto the hard disk proceeds
automatically (default setting) according to the following settings. The settings
can be changed between long-period recording and high-quality recording in five
steps. (See page 47.)
•
Hard disk recording areas:
Normal recording area: 80%
Alarm recording area: 19%
Archive area: 1%
•
Picture quality: EN (Enhanced)
•
Recording method: Field
•
Recording speed: 0.10 seconds (54H)
Note: Playback is possible during recording. When the PLAY/STOP button is
Timer recording stops when the set end time is reached.
5
The TIMER indicator swithes off and the recording symbol (a) disappears from
the operating display and recording stops.
TIMER
Note:
•
Press the TIMER button to stop timer recording. Timer recording then stops.
•
When the remaining area in the normal recording area drops below the set
amount, the FULL indicator on the front panel flashes. If recording continues
under these conditions, the recording area becomes full and recording stops.
In the RECORDING AREA SET settings, carry out the AREA FULL RESET
operation for the normal recording area.
Recording will then be possible from the beginning again. (See page 44.)
pressed during recording, c appears in the operating display and images
are played back from the point where recording began. (See page 19.)
14
10-05-01
19:30:00 EN 0.10SEC
POWER
FULL
ALARM FULL
LOC
English
Advertisement
Table of Contents
