Cleaning Between Product Runs - Taylor QS12 Operating Instructions Manual

CAUTION: The grill is hot. To prevent
personal injury, always use the handle to lower the
upper cook surface.
Step 7
If the timer is programmed, press the large red TIMER
button. A tone will sound for two seconds, alerting the
operator that the COOK cycle has been initiated. The
timer will count down in seconds. When five seconds
are left in the cook time, a tone will sound to alert the
operator that product is ready for serving. Raise the
upper cook surface. (If a second timer is entered,
subtract that amount from the total time and a tone will
sound. Press the large red TIMER button to stop the
tone and the control will continue to count down.)
EXIT
UF
TEMP
MENU TIME
UM
UR
LR
LM
LF
M A N U F A C T U R E D B Y T H E
R O C K T O N , I L L I N O I S
Figure 25
To cancel the tone, press the large red TIMER button.
Step 8
Carefully remove product with a safe cooking utensil
in the same order the product placed on the grill.
071102
Operating Procedures
14294
UP DOWN
I
0
T A Y L O R C O M P A N Y
U . S . A .

Cleaning Between Product Runs

After each run of product, the grill must be cleaned to
ensure proper cooking.
Step 1
Using a grill scraper, scrape residue from the lower
cook surface (scrape from front to back only).
Step 2
Use a rubber wiper squeegee to clean release material
on the upper cook surface. Hold the handle at a slight
upward angle with wiper end facing downward. Wipe
the material using a downward motion. DO NOT use
extreme pressure or force. Improper procedures will
tear or crease the release material.
Note: DO NOT use a scraper, sharp utensils, or
abrasives for cleaning the upper cook surface.
24
Figure 26
Figure 27
Models QS12 & QS24