Taylor QS12 Operating Instructions Manual page 31

IMPORTANT: Do not use a jet of water to
clean or rinse the grill.
Step 12
Use the rubber wiper squeegee to remove excess
liquid from the upper and lower surfaces.
IMPORTANT! Do not scrape the upper surface
with metal utensils. It is aluminum and will scratch
very easily.
Step 13
Repeat Steps 10 and 11 if necessary, but apply cleaner
only to soiled areas.
Step 14
Remove any small carbon spots with the rubber
squeegee.
Step 15
Using a damp cloth, wipe down all exterior stainless
steel of the upper cook surface (especially behind the
rear of the upper cook surface, next to arm assembly).
Note: Grills should be removed from cooking alcoves
in order to clean the rear section of the upper cook
surface.
Step 16
Clean lower grill by pouring warm water carefully on
the surface while brushing with sturdy brush.
CAUTION: Wear rubber gloves to avoid
hot steam.
Step 17
Continue to add water and brush the surface until the
grill is cool enough to squeegee dry.
Step 18
Wipe the cook surface(s) twice with a clean, damp
towel.
Step 19
Wipe all areas of the grill with a clean, damp towel.
Step 20
Wipe all exterior stainless steel panels around the
entire grill.
Models QS12 & QS24
CAUTION:
Never use cold water or ice to cool the
S
upper cook surface or lower grill plate.
Never use grill screens on the upper cook
S
surface or lower grill plate.
Never use any other abrasives or cleaners
S
other than approved food service cleaners
and degreasers.
Never spray excessive amounts of water on
S
the grill.
Never pour or spray liquid of any type on
S
the top of the upper cook surface.
Step 21
Place release material sheet(s) on the warm lower grill
plate and thoroughly wipe down both sides with a
clean, damp grill cloth.
CAUTION:
Never attempt to clean release material
S
sheets on a cold surface.
Never use a hot hose for cleaning release
S
material, or soak release material sheets in
liquid.
Never fold, crease or touch release material
S
sheets with sharp objects.
Never allow the grill scraper or abrasive
S
cleaning materials to come in contact with
release material sheets.
Step 22
Apply a light coat of shortening to the entire lower grill
plate.
27
Operating Procedures