6
2.2 Dockside and open water procedures
WARNING: Dockside and open water procedures.
The ST70 Pilot must be prepared for use in accordance with the
Commissioning Procedures before it is used for operational purposes.
Failure to comply with this could result in death, personal injury, damage to
your boat and/or poor product performance.
The following procedures are described in the ST70 Autopilot Controller/SmartPilot X
Commissioning Instructions and should be performed in the prescribed order when
there is any change in vessel configuration:
•
Vessel type
•
Drive type
•
Rudder check
•
Motor check
•
Compass calibration
•
Auto learn.
2.3 General setup procedures
The setup procedures available depend on the vessel profile as set up during
commissioning (Fishing, Sail or Power), and whether the ST70 Pilot is in Standby or
Auto mode.
Procedure
Pilot view (see Pilot view on page 22)
SmartPilot X Commissioning Instructions)
page 15):
Auto Tack
Gybe Inhibit
Wind Trim
Patterns (see Power boat and fishing boat setup procedures
on page 17)
ST70 Pilot Controller Reference Guide
Sail
x
x
x
x
x
x
Fishing
Power
x
x
x
x
x
x
x
x
x
x
x
x