System Functionality; Commissioning Requirement - Raymarine ST70 User Reference Manual

4
Setup procedures
Setup procedures are carried out during Commissioning to set:
• Language
• Vessel Type
• Time format
• Date format
• Method used for ground wind calculation
• Magnetic variation
• Response rate
If you need to change any of these after the pilot has been commissioned, refer to the
appropriate procedure in the ST70 Autopilot Controller/SmartPilot X Commissioning
Instructions.

1.4 System functionality

Your ST70 Pilot is fitted with Raymarine SeaTalk
connected to any of the following Raymarine systems, using suitable adaptor cables
as necessary:
• SeaTalk
2
• SeaTalk
ng
• SeaTalk
SeaTalk ng
When connected to a SeaTalk
Power protocol
Power to the ST70 Pilot can be switched on and off using the power button. However,
where a Pilot is part of a system, it may be more convenient to switch power for the
entire system from a central circuit breaker.
In this case, when system power is switched ON again:
• An ST70 Pilot that was switched on when power was last switched off will return to
the switched ON state.
• An ST70 Pilot that was OFF when system power was last switched OFF will
remain OFF and will need to be switched ON using the power button.

1.5 Commissioning requirement

WARNING: The ST70 Pilot must be prepared for use in accordance with
the Commissioning Procedures, before it is used for operational purposes.
Failure to comply with this could result in death, personal injury, damage
to your boat and/or poor product performance.
ST70 Pilot Controller Reference Guide
ng
ng
system, the ST70 Pilot repeats the data on the bus.
connectors, but it can be