General Maintenance; Dealer Maintenance Procedures - Raymarine S1000 User Manual

81245_1.fm Page 31 Tuesday, December 7, 2004 10:08 AM

General maintenance

Routine checks
The S1000 computer and S100 controller do NOT contain user-serviceable
parts. If you remove the main cover you will invalidate the warranty. It
should be serviced only by authorized Raymarine service technician.
As a result, user maintenance is limited to the following checks
• make sure all cable connectors are firmly attached
• examine for signs of wear or damage – replace any damaged
cables
• replace batteries when necessary
Cleaning the S1000 and S100
Take care when cleaning the display. Avoid wiping the display screen with a
dry cloth as this could scratch the screen coating. If necessary, only use a
mild detergent.
Never use chemical or abrasive materials to clean the computer or
controller. If it is dirty, wipe it with a clean, damp cloth.

Dealer Maintenance Procedures

This section includes procedures that have a significant impact on autopilot
operation and can affect your boat's safety. You will not need to follow
these procedures in normal operation. We therefore recommend that these
are only performed by authorized service personnel.
Accessing the dealer calibration area.
From STANDBY mode, press and hold STANDBY for 2 seconds to enter
PILOT SETUP.
Then press and hold mode for 5 seconds until the dealer calibration screen
is displayed.
User Guide 31