Water Ingress; Disclaimer; Suppression Ferrites; Connections To Other Equipment - Raymarine EVOLUTION EV-1 Installation Instructions Manual

Caution: Product cleaning
When cleaning products:
• Switch off power supply.
• Lightly rinse or flush with clean, cool fresh water.
• Do NOT use: abrasive, acidic, ammonia, solvent or other chemical based
cleaning products.
• Do NOT use a jet wash.
Caution: Service and maintenance
This product contains no user serviceable components. Please refer all
maintenance and repair to authorized Raymarine dealers. Unauthorized repair
may affect your warranty.

Water ingress

Water ingress disclaimer
Although the waterproof rating capacity of this product meets the stated water ingress protection
standard (refer to the product's
failure may occur if the product is subjected to high-pressure washing. Raymarine will not warrant
products subjected to high-pressure washing.

Disclaimer

Raymarine does not warrant that this product is error-free or that it is compatible with products
manufactured by any person or entity other than Raymarine.
Raymarine is not responsible for damages or injuries caused by your use or inability to use the
product, by the interaction of the product with products manufactured by others, or by errors in
information utilized by the product supplied by third parties.

Suppression ferrites

• Raymarine cables may be pre-fitted or supplied with suppression ferrites. These are important for
correct EMC performance. If ferrites are supplied separately to the cables (i.e. not pre-fitted), you
must fit the supplied ferrites, using the supplied instructions.
• If a ferrite has to be removed for any purpose (e.g. installation or maintenance), it must be replaced
in the original position before the product is used.
• Use only ferrites of the correct type, supplied by Raymarine or its authorized dealers.
• Where an installation requires multiple ferrites to be added to a cable, additional cable clips should
be used to prevent stress on the connectors due to the extra weight of the cable.

Connections to other equipment

Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected to other equipment using a cable not supplied by
Raymarine, a suppression ferrite MUST always be attached to the cable near the Raymarine unit.

Declaration of Conformity

FLIR Belgium BVBA declares that the following products are in compliance with the Radio Equipment
Directive (RED) 2014/53/EU:
10
Technical Specification
), water intrusion and subsequent equipment