Dust Ports; Dust Collection - Grizzly G0563 Owner's Manual

Dust Ports

Components and Hardware Needed:
Dust Ports .......................................................... 2
Phillips Head Screws ⁄
1
Flat Washers / " ................................................ 4
1
4
Hinge Pins ......................................................... 2
Tools Needed:
Phillips Head Screwdriver #2 ............................ 1
To mount dust ports:
1. Align rear dust port holes with tapped holes
on back of sander.
2. Insert Phillips head screws and wash-
ers through aligned holes and tighten
(see Figure 8).
Figure 8. Installing dust port.
3. Align hinges of front dust port with hinges on
front of sander.
4. Mount front dust port using hinge pins and
latches in a similar fashion to dust port cover.
(Refer to Dust Port Cover on this page.)
Model G0563/G0564 (Mfd. Since 10/11)
Qty
"-20 x ⁄ " ...................... 4
3
4 8

Dust Collection

There are two 4" dust collection ports for the
sander that should be connected to a dust collec-
tor. The port locations are shown in Figure 9.
Figure 9. G0563/G0564 dust ports.
Components and Hardware Needed:
Dust Collector .................................................... 1
Dust Hoses 4".................................................... 2
Hose Clamps 4" ................................................. 4
Tools Needed
Phillips Head Screwdriver #2 ............................ 1
To connect your machine to a dust collection
system:
1.
Use 4" diameter hose and clamps to connect
a dust collection system to your dust ports.
Model T10116 (Figure 10) can be purchased
separately through our catalog or online for added
dust collection when spindle sanding.
Figure 10. Model T10116 auxiliary dust table.
Qty
-19-