Tables; Spindle Connector; Eccentric - Grizzly G0563 Owner's Manual

Tables

The tables of the Model G0563/G0564 can
be kept rust-free with regular applications of
products like G96 Gun Treatment, SLIPIT
®
T-9 (see Accessories on Page 28 for
Boeshield
®
more details).

Spindle Connector

The spindle connector connects the shafts from
the motor to the gearbox and is secured by two
set screws that need to be tightened every time
the gearbox oil is filled (every 500 hours).
Tools Needed:
Hex Wrench 5mm .............................................. 1
Hex Wrench 4mm .............................................. 1
Open End Wrench 10 x 12mm .......................... 1
To secure spindle connector set screws:
1. Refer to Lubrication Steps 1 –3 on Page 29
to remove gearbox cover.
2. Tighten set screws shown in Figure 32.
Figure 32. Spindle connector set screws.
3.
Re-install gearbox cover.
Model G0563/G0564 (Mfd. Since 10/11)
The eccentric on the Model G0563/G0564 is con-
nected to the shaft by a set screw. This set screw
, or needs to be tightened every time the gearbox oil
®
is filled (every 500 hours).
Tools Needed:
Hex Wrench 5mm .............................................. 1
Hex Wrench 4mm .............................................. 1
Open End Wrench 10 x 12mm .......................... 1
To secure eccentric set screw:
1. Refer to Lubrication Steps 1–3 on Page 29
to remove the gearbox cover.
2.
Tighten set screw on the eccentric shown in
Figure 33.
3. Re-install gearbox cover.

Eccentric

Figure 33. Eccentric set screw.
-31-