Miter Gauge - Grizzly G0563 Owner's Manual

To horizontally adjust table:
1. Move table lock levers to the loose position,
as illustrated by labels on machine.
2. Push or pull table until there is a gap of no
more than / " from sanding belt, as shown
1
16
in Figure 17.
Maximum
⁄ " gap
1
16
Table Lock
Levers
Figure 17. Horizontal table adjustment.
3.
Move table lock levers to the locked position
to secure table position.
-24-

Miter Gauge

The miter gauge needs to be adjusted perpen-
dicular to the face of the belt when it is mounted
in the table slot.
To adjust miter gauge:
1.
Use a machinist square with one edge against
face of miter gauge and the other against belt
face, as shown in Figure 18.
Figure 18. Squaring miter gauge to belt.
2.
Loosen lock knob on miter gauge to adjust it
flush with edge of the square.
3.
Tighten lock knob, and verify the setting.
Note—Sometimes the tightening procedure
can affect adjustment.
4. Loosen the screw that secures the angle
pointer and adjust pointer to the 0˚ mark on
scale.
5. Retighten screw that secures the angle point-
er.
Model G0563/G0564 (Mfd. Since 10/11)