54
AutoTurn
The AutoTurn setting defines the amount of course
change when performing an auto turn.
1. Use the Preliminary procedure above to display
the AutoTurn page
2. Scroll to set the appropriate value.
OK
3. Press
Drive settings menu.
Reverse rudder reference
The Reverse rudder reference page is available
only if the rudder reference option is fitted, to
enable you to reverse the sense of the rudder
reference indicator.
Checking autopilot operation
After changing any autopilot drive setting, check
that the autopilot operates satisfactorily as follows:
1. Display a Pilot View page. If the Drive settings
menu is displayed:
CANCEL
2. Press
CANCEL
3. Press
4. Check that it is safe to engage autopilot control, then press
autopilot performance in Auto mode.
5. If the autopilot:
•
Performs satisfactorily, setup is complete.
•
Does not perform satisfactorily, press
and carry out any further adjustments as necessary.
to save the setting and return to the
to return to the Advanced options menu.
to return to the Pilot View page.
ST70+ User Reference Manual
AutoTurn
Defines the course change that the vessel
i
will undertake when performing an AutoTurn.
Press OK to accept
Reverse Rudder Reference
Reverses the rudder.
i
Press OK to accept
AUTO
STANDBY
to return to Standby mode
90
Port
to check the