Raymarine ST70+ Operating Manual page 24

16
OK
3. Press
page.
4. Scroll to select either Instrument or Autopilot,
as required.
Note:
From this point, you must use a keypad type appropriate
to the display type you have selected.
OK
5. Press
play the Assign group page.
6. Scroll to the name of the group to which you
want to assign the display.
• Pilot Controller group name options are:
Pilot-1, Pilot-2, Pilot-3, Pilot-4 and Pilot-5
• Instrument group name options are:
Inst-Helm1, Inst-Helm2, Inst-Cockpit,
Inst-Flyb., Inst-Mast, Inst-1, Inst-2, Inst-3,
Inst-4, Inst-5, Inst-6, Inst-7, Inst-8, Inst-9, Inst-10, Inst-11, Inst-12, Inst-13, Inst-
14 and Inst-15.
OK
7. Press
display the Assign order in group page. Each
display in a group has a discrete number, and
these numbers determine the order in which
displays are selected within the group during
normal operation, when the Select Display but-
ton is used.
8. Scroll to the required number.
OK
9. Press
play the Link keypad to group page.
10. If you have not allocated keypads to the group containing the display you are set-
ting up:
i. Press
ii. Wait until the confirming popup disappears.
iii. Repeat i and ii for each keypad you want to link to this group.
Note:
Remember you can only link Instrument keypads to In-
strument groups, and Pilot Controller keypads to Pilot
Controller groups.
11. When you have allocated all the required key-
pads to this group, press
group settings and display the Configure this
display page.
12. Repeat steps 3 to 11 for each display.
to display the Display type setup
to confirm the display type and dis-
to save the group assignment and
to save the group settings and dis-
OK
at a keypad you want to link to this group.
MENU
ST70+ User Reference Manual
Display type
Configure this display as an instrument or
i
autopilot controller
Assign group
Assign into a group of one or more displays. All
i
displays must be the same type.
Assign order in group
Assign the order of this display
i
within the group.
Link keypad to group
to save the
Autopilot
Press OK to accept
Pilot-2
Press OK to accept
2
Press OK to accept
Press OK on each
keypad that you want
to link to this display
group
Press MENU to finish