Raymarine ST70+ Operating Manual page 35

Chapter 2: Commissioning Procedures
To access the required transducer:
1. With any operational Instrument page
displayed, press
Menu.
2. Scroll to Advanced Options, then press
3. At the Advanced Options menu, scroll to
Transducer Setup.
OK
4. Press
search page.
OK
5. Press
transducers. At the end of the search, a Search
results page is displayed.
6. With the search results page displayed, press
OK
to access the Transducers found menu.
7. Set up the following:
• The correct Depth Offset, using the proce-
dure described under either Calibrating
conventional transducers or Calibrating
smart transducers as appropriate
• The correct Water Temperature using the
procedure described under either
Calibrating conventional transducers or Calibrating smart transducers as
appropriate.
• The Trim tabs (if applicable).
MENU
to display the Main
to display the Transducer setup start
again to initiate a system search for
Advanced Options
OK
Transducer Setup
Press OK to select
Transducer Setup
Press OK to continue
Search Results
If not correct, press CANCEL and
i
check connections.
Press OK to continue
Transducers Found
Raymarine
i
Serial no.135260
Press OK to select
27
ST70+ will now
search the network
for transducers.
Press CANCEL to abort.
Found:
1 Depth
1 Speed
1 Wind
0 DST800
0 DT800
1 Trimtabs
Depth