HP Compaq 6000 Pro Maintenance & Service Manual page 103

14. Remove the WLAN module (see
15. Remove the fan (see
16.
Remove the graphics board (see
17. Remove the system board shield (see
18. Disconnect all cables from the system board, noting their location for reinstallation.
19. Remove the nine screws (circled in image) that secure the system board to the computer.
20. Lift the right side of the system board enough so the board clears the posts (shown with arrows in
image), and then remove the system board by lifting up to the right and out of the computer.
Figure 7-53 Removing the system board
To install the system board, reverse the removal procedures.
WLAN Module on page
Fan on page 89).
Graphics Board on page
System Board Shield on page
73).
65).
92).
System Board
95