System Display; Sensor Batteries - Triumph Speed Triple Handbook

System Display

Warning
Do not attempt to switch between front
and rear tyre display modes with the
motorcycle in motion as this may lead to
loss of motorcycle control and an accident
5
1
6
cfio_14
1. TPMS symbol
2. Tyre pressure display
3. Front tyre, identified
4. Rear tyre, identified
5. Button A
6. Button B
To access the tyre pressure display, turn the
ignition to the ON position.
Press and release button 'A' until psi or bAr is
visible in the display screen.
Press and release button 'B' to select the front
or rear tyre pressure.
When the tyre pressure monitoring system
has been selected, —— psi or bAr will be
visible in the display screen until the
motorcycle is travelling at a speed greater
than 12 mph (20 km) and the tyre pressure
signal is received.
General Information
To exit the tyre pressure display, press and
release button 'A' to the desired display.

Sensor Batteries

When the battery voltage in a pressure
sensor is low, LO bAt will be displayed and
the TPMS symbol will indicate which wheel
sensor has the low battery voltage. If the
batteries are completely flat, only dashes will
be visible in the display screen, the red TPMS
warning light will be on and the TPMS
symbol will flash continuously. Contact your
authorised Triumph dealer to have the sensor
replaced
3 recorded in the spaces provided on page 34.
F
R
4
1
2
cgfr_6
1. TPMS symbol
2. Display screen
3. Front tyre, identified
4. Rear tyre, identified
5. TPMS warning light
With the ignition switch turned to the ON
position,
continuously and the TPMS warning light
remains on there is a fault with the TPMS
system. Contact your authorised Triumph
dealer to have the fault rectified.
and the new serial number
5
3
F
R
4
2
if the TPMS symbol flashes
35