Storage
Preparation after Storage
Install
the
battery
(if
page 103).
If the motorcycle has been stored for more
than four months, change the engine oil (see
page 75).
Check all the points listed in the Daily Safety
Checks section.
Before starting the engine, remove the spark
plugs from each cylinder.
Put the side stand down.
118
Crank the engine on the starter motor several
times until the oil pressure light goes out.
removed)
(see
Replace the spark plugs, tightening to
12 Nm, and start the engine.
Check and if necessary correct the tyre
pressures (see page 99).
Clean the entire vehicle thoroughly.
Check the brakes for correct operation.
Test ride the motorcycle at low speeds.