System Display; Sensor Batteries - Triumph Bonneville T100 Owner's Handbook Manual

System Display

Warning
Do not attempt to switch between
front and rear tire display modes with
the motorcycle in motion as this may
lead to loss of motorcycle control and
an accident.
4
1. TPMS warning light
2. TPMS symbol
3. Tire pressure
4. Front and rear tire indicators
To view the tire pressure display:
Make sure
▼
stationary and in neutral. Turn the
ignition to the ON position.
Press and release
▼
button until PSI or bAr is shown in
the display screen.
Press and hold the SCROLL button
▼
for one second to change between
PSI and bar.
Once PSI or bar has been selected,
▼
press and release
button to select the front or rear
tire pressure.
1
2
3
the motorcycle
the SCROLL
the SCROLL
GENERAL INFORMATION
When the tire pressure monitoring
▼
system has been selected, —— PSI
or bAr is shown in display screen
until the motorcycle is traveling at a
speed greater than 12 mph (20 km/h)
and the tire pressure signal is
received.
To exit the tire pressure display,
▼
press and
button until the required display
screen is shown.

Sensor Batteries

When the battery voltage in a pressure
sensor is low, LO bAt will be displayed
and the TPMS symbol will indicate
which wheel sensor has the low battery
voltage. If the batteries are completely
flat, only dashes will be visible in the
display screen, the red TPMS warning
light will be on and the TPMS symbol
will flash continuously. Contact your
authorized Triumph dealer to have the
sensor replaced and the new serial
number recorded in the spaces provided
on page 52.
With the ignition switch turned to the
is
ON position, if the TPMS symbol flashes
for 10 seconds and then remains on
there is a fault with the TPMS system.
Contact your authorized Triumph dealer
to have the fault rectified.
release the SCROLL
53