Preparation After Storage - Triumph Trophy Handbook

Storage

Preparation After Storage

Install the battery (if
page 148).
If the motorcycle has been stored for more
than four months, change the engine oil (see
page 121).
Check all the points listed in the Daily Safety
Checks section.
Before starting the engine, remove the spark
plugs from each cylinder.
162
Put the side stand down.
Crank the engine on the starter motor several
removed) (see
times until the oil pressure light goes out.
Replace the spark plugs, tightening to
12 Nm, and start the engine.
Check and if necessary correct the tyre
pressures (see page 167).
Clean the entire vehicle thoroughly.
Check the brakes for correct operation.
Test ride the motorcycle at low speeds.