Safety Switch; Tilting The Sewing Machine Head - JUKI LK-1900A Instruction Manual

7. Safety switch

Remove tape q fixing the lever section of safety switch w.
1. When using the safety switch without removing tape q, it is very dangerous since the
sewing machine works even in the state that it is tillted.
Impor tant
2. In case error 302 occurs when the sewing machine works after setup, loosen the safety
switch fitting screw with a screwdriver, and lower the switchto the downside of the sewing
machine.

8. Tilting the sewing machine head

WARNING :
Tilt/raise the sewing machine head with both hands taking care not to allow your fingers to be caught in
the head. Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start
of the sewing machine.
q
w
q
w
When tilting the sewing machine head, tilt the head
gently until it comes in contact with head support rod
q.
1. Before tilting the sewing machine head,
make sure that head support rod qis
attached to the machine table.
2. When raising the sewing machine
head, do not raise it while holding
motor cover w. It will be the cause of
breakage of motor cover w.
3. Be sure to tilt the sewing machine head
on a flat place to prevent it from falling.
7
w