10. Adjustment of the wiper spring
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
w
q
11. Installing the save button bar (accessory part)
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
w
r
e
3.5 to 4mm
Wiper spring
trimming in between wiper
Correct properly the tension of wiper spring
the tension at that time becomes 20 to 30 g (a little
higher tension than that of the bobbin thread coming
out of the bobbin case).
1) Install save button bar
q
2) Adjust so that a clearance of 3.5 to 4 mm is provided
3) To adjust the raising amount of the save button
70
q
retains the needle thread after thread
If the retaining of the needle thread is
excessive, the thread may protrude from
the upper side of the button.
e
w
with hexagon screw
.
between the center of the button and the top end
of the save button bar.
r
bar, loosen screw
, and move the save button
bar up or down.
w
and the wiper spring.
q
so that
q
on button clamp base