Installing The Drain Receiver And The Head Support Rubber; Safety Switch - JUKI LK-1900B series Instruction Manual

3-8. Installing the drain receiver and the head support rubber

❻
❶
❹

3-9. Safety switch

Remove tape ❶ fixing the lever section of safety switch ❷ .
1. When using the safety switch without removing tape ❶ , it is very dangerous since the sewing
machine works even in the state that it is tillted.
2. In case error 302 occurs when the sewing machine works after setup, loosen the safety switch
❷ fitting screw with a screwdriver, and lower the switch to the downside of the sewing ma-
chine.
1) Fix drain receiver ❷ in the installing hole of table
❸
2) Screw poly-oiler ❹ in waste oil reservoir ❷ .
❷
3) Insert sewing-machine waste oil pipe ❺ into po-
4) Insert head support rubber ❻ into table ❶ .
5) Pass bundle ❼ of cords through slotted hole ❽ in
❼
❽
❺
❻
❶
❷
－ －
8
❶ with two setscrews ❸ .
ly-oiler ❹ .
the table.
1. Insert drain pipe ❺ until it will go no fur-
ther so that it does not come off drain
bin ❹ when tilting the machine head.
2. Remove the tape fixing drain pipe ❺ .
❷