Cleaning; Connecting The Phone; Keypad - Snom 360 Manual

cleaning liquids as they might damage the surface or the internal
electronics of the phone.
1
to the jack labeled "
labeled "
data link. The second RJ45 connector, labeled "
further Ethernet devices without the need for a second Ethernet connection
line.
of the power supply into the connector labeled "
and hook up the casing into the mains.
jack labeled "
case of the handset cord, on the bottom shell of the phone (see Fig. 1 in
the chapter Setting up the phone, above).

Keypad

digits and letters. Depending on the operating mode, different actions can
be performed (see the table below):
14 • Installation
VoIPon www.voipon.co.uk
[ 3 6 0 U
S N O M

Cleaning

To clean the snom 360, use an anti-static cloth. Please avoid

Connecting the phone

First connect one end of the handset cable to the handset and then
" on the left-hand side of the phone's bottom.
Next plug the Ethernet (network) cable into the RJ45 connector
", and plug the other end into the network side to establish a
If you are using an external power supply, please insert the plug
If you want to use a headset, it can be connected to the audio
" on the bottom side of the snom 360.
Clip the cords into the appropriate slots on the footstand or, in the
The numeric keypad with the keys 0 to 9, *, and # is used to enter
• Entry of digits only (e.g., when dialing a phone number)
• Typing in letters and digits by pressing the keys
repeatedly (similar to a cellular phone), etc.
sales@voipon.co.uk
M V 1 . 0 0 ]
S E R A N U A L
", is for daisy-chaining
" next to the data line
Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030