Table of Contents
Advertisement
VB14N
5.5.1 Code Verifier
If the VB14N is used as a Code Verifier, the verifier code can be configured in software through the
Genius™ configuration program. However it is also possible to use one of the inputs to trigger when
the scanner should store a code read as the verifier code.
The Code Verifier parameter must be enabled, and the configuration parameters to allow correct Code
Type reading must be saved to the scanner in order to read the verifier code.
When the selected input is activated, the next read code will be stored as the verifier code in the
scanner's non-volatile (Flash) memory.
For more details see the Verifier Parameters in the " Software Configuration Parameter Guide" Help
file.
5.6 OUTPUTS
Two general purpose outputs are available. The following pins are present on the 25-pin connector of
the scanner:
25-pin
Name
9
Vdc
8
O1+
22
O1-
11
O2+
12
O2-
7
GND
The meaning of the two outputs Output 1 and Output 2 can be defined by the user (No Read, Right,
Wrong, etc.). Refer to the Genius™ Help On Line.
By default, Output 1 is associated with the No Read event, which activates when the code signaled by
the external trigger is not decoded, and Output 2 is associated with the Complete Read event, which
activates when all the selected codes are correctly decoded.
The output signals are fully programmable being determined by the configured Activation/Deactivation
events, Deactivation Timeout or a combination of the two.
V
max = 30 Vdc
CE
I max = 40 mA continuous; 130 mA pulsed
58
Function
Power Source - Outputs
Output 1 +
Output 1 -
Output 2 +
Output 2 -
Power Reference - Outputs
VB14N
USER INTERFACE
C
8/11
O+
22/12
O-
E
Figure 61 - Open Emitter Output Connections
VB14N
USER INTERFACE
C
8/11
O+
22/12
O-
E
Figure 62 - Open Collector Output Connections
Vext 30 Vdc max.
Vext 30 Vdc max.
Advertisement
Table of Contents
