Table of Contents
Advertisement
VB14N
2.1.1 Indicators
The five LEDs on the side of the scanner (
READY
(green)
GOOD
(green)
TRIGGER
(yellow)
COM
(yellow)
STATUS
(red)
* In On-Line mode the TRIGGER LED corresponds to the active reading phase signaled by the Presence Sensor.
In Automatic and Continuous modes the TRIGGER LED is always on indicating that the reader is ready to read a
code.
** When connected to a Fieldbus network through the CBX500, the COM LED is always active, even in the
absence of data transmission, because of polling activity on the Fieldbus network.
During the reader startup (reset or restart phase), all the LEDs blink for one second.
On the back of the reader near the cable, the "POWER ON" LED indicates the laser scanner is
correctly powered.
2.2 ID-NET™
The ID-NET™ is a built-in high-speed interface dedicated for high-speed
scanner interconnection. The ID-NET™ is in addition to the Main and
Auxiliary serial interfaces.
The following network configurations are available:
ID-NET™ M/S Synchronized: Single station – multiple scanners
CBX100
16
Figure A
) indicate the following:
This LED indicates the device is ready to operate.
This LED confirms successful reading.
This LED indicates the status of the reading phase. *
This LED indicates active communication on main serial port. **
This LED indicates a NO READ result.
CBX100
CBX100
ID-NET™ interface allows local connection of
multiple scanners reading different sides of the
same target. All scanners share a single
presence sensor and activate/deactivate
simultaneously.
At the end of each reading phase a single data
message is transmitted to the host.
Thanks to ID-NET™, data communication
among scanners is highly efficient so that an
immediate result will be available.
Advertisement
Table of Contents
