Table of Contents
Advertisement
5. AC POWER
Overview
•
AC Power Cord Connection
•
AC Power Voltage
•
Switching on the projector
5.1 AC Power Cord Connection
How to connect the AC Power Cord?
Use the supplied power cord to connect your projector to the wall outlet.
1. Plug the female power connector into the male connector at the front side of the electronic block.
OFF
ON
POWER MAINS
Image 5-1
AC Power Cord Connection
How to prepare the AC Power Cord?
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals
in your plug, proceed as follows:
•
The yellow/green wire is ground and must be connected to the terminal in the plug which is marked by the letter E or colored
yellow and green.
•
The blue (white) wire is neutral and must be connected to the terminal marked with the letter N or colored black.
•
The brown (black) wire is the line and must be connected to the terminal marked with the letter L or colored red.
CEE 7 Plug
Green and yellow : Ground
Blue : Neutral
Brown : Line
Image 5-2
Power cord plugs
5.2 AC Power Voltage
What is the AC Power Voltage?
The power input voltage is autoranging between 100V (-10%) and 240V (+6%).
Which Fuses are used?
Following fuses are used:
•
2x T10A (Order number R314521)
•
1x F10A (Order number R314155)
For continued protection against fire hazard: replace with the same type of fuse and refer replacement to
qualified service personnel.
R5976257 BARCO REALITY 909 15/03/2003
See installation instructions before connecting to the supply.
Voir la notice d' installation avont de raccorder au r éseau.
R
800 periphals
PORT 3
COMM. PORT
G
B
DEFOCUS
Comp / H-Sync V-Sync
PORT 4 / 5
PORT 2
ANSI 73.11 Plug
Green and yellow : Ground
White : Neutral
Black : Line
X-POS Y-POS
OFF - ON
OFF - ON
green: operation
red: standby
75 Ohm
75 Ohm
PORT 1
PROJECTOR MODE
5. AC Power
23
Advertisement
Table of Contents
