Sharp MX-FXX1 Service Manual page 40

SW Bit
Item
No. No.
40 1 CSI sending
2-3 CED signal sending
time
4 CED/ANSam detection
time
5-6 Waiting time for start of
CED/ANSam sending
7-8 Not used
41 1-2 Start of CNG sending
3 Time between DCS-
TCF
4-8 Not used
42 1-2 RCP sending count
3 RTC EOL sending
count
4 F.A.S.T function
5-8 Not used
SW selection and function
Setting to determine whether or not to send the CSI signal.
The CSI signal contains the transmission source number.
"0": Yes (send the CSI signal)
"1": No (do not send the CSI signal)
This sets the time over which the CED signal is sent.
"00": 3 seconds
"01": 4 seconds
"10": 5 seconds
"11": No
Setting for the ANSam signal is performed using a separate SW "51-7,
8" (V.8 mode ANSam signal sending time).
This sets the time up until determination of the signal when detecting
CED/ANSam signals.
"0": 500ms
"1": 1000ms
This sets the waiting time from the start of FAX reception status to
sending of the CED/ANSam signal over the line.
"00": 2.25 seconds
"01": 3 seconds
"10": 4 seconds
The initial value is reverted to if a value outside of the setting range is
set.
This sets the waiting time up until line connection and sending of the
CNG signal over the line.
"00": 0.5 seconds
"01": 1 second
"10": 1.5 seconds
"11": 2.0 seconds
Setting to determine how many seconds in the interval between DCS
transmission and sending of the TCF signal.
"0": 75msec
"1": 150msec
75±20ms in the ITU-T standard.
Setting to determine the number of RCP frames sent during Phase-C
sending in the ECM system.
"00": 3 times
"01": 6 times
"10": 9 times
"11": 12 times
In cases where the other party's machine cannot detect RCP frames,
RCP detection becomes easier.
Setting to determine the number of EOL frames sent as RTC during
Phase-C sending.
"1": 12 times
"0": 6 times
In cases where the other party's machine cannot detect RTC frames,
RTC detection becomes easier.
This sets the management function performed in the FAX
communication procedure through the telephone line.
"0": No
"1": Yes
Valid only in North America.
MX-FXX1 SIMULATIONS, FAX SOFTWARE SWITCH 5 – 31
Initial value
0 Yes
0 3 seconds
0
0 500ms
0 2.25 seconds
0
0
0
1 2.0 seconds
(North America/Taiwan/
1
Middle East/Other3/Rusia)
0 0.5 seconds (Australia/
U.K./France/Germany/
0
Sweden/Finland/Norway/
Denmark/Netherlands/
Italy/Switcherland/Austria/
New Zealand/China/
Singapore/Indonesia/
Thailand/Malaysia/India/
Philippine/Hong Kong/
Slovakia/South Africa/
Spain/Portuguese/
Luxemburg/Belgium/
Czech/Hungary/Greece/
Poland)
0 75ms
0
1
0
0
0
0 3 times
0
0 6 times
0 No
0
1
1
1
System
settings