Sharp MX-FXX1 Service Manual page 52

SW Bit
Item
No. No.
72 8 Relay data output
73 1 Not used
2 F code communication
error handling
3 F code password
transmission setting
when the other party's
machine has no
password capacity
4 Remaining receivable
memory
5 Setting of received
document output when
receiving
6-7 Not used
8 Rotated printing
74 1-4 Magnification setting in
automatic reduction
5 Determination of sub-
scan length
(determination setting
when selecting the
page)
6-8 Not used
75 1-8 Not used
76 1-8 Not used
77 1 Setting of the reception
width of 11x17 sheet
2 Not used
SW selection and function
Setting to determine whether or not to output documents received from
the relay command station when F code relay broadcast instructions
are received.
"0": Output
"1": Do not output
Setting to determine whether or not to re-send at times of F code
communication.
"0": Re-send
"1": Do not re-send
However, do not re-call in cases where the "Re-call permission at times
of communication error" setting is at "0: Prohibited."
Do not re-send when the other party's machine does not have F code
functions.
Setting to determine the communication procedure in cases where the
other party's machine has no F code password capacity when
conducting F code communication.
"0": Disconnect with DCN
"1": Send with password
Setting to determine whether to issue a call when remaining memory
reaches 64KB or less or 128KB or less.
"0": 128KB
"1": 64KB
Setting to determine whether to output data received in FAX, Internet
FAX communications en masse or to output 1 page at a time as it is
received.
"0": Save and output en masse following completion of reception
"1": Output 1 page at a time
Setting to determine whether or not to rotate and output received data
when this is possible at times of receiving and printing FAX and Internet
FAX data.
"0": Permitted (rotate and print)
"1": Prohibited (do not rotate and print)
Setting to determine the page length for reduced printing of documents
received when automatic reduced printing is set at permitted.
Percentage threshold that can be reduced (excluding reduction
between fixed page sizes)
Setting can be made over the range of 85% to 100% in 1% increments
by binary inputting (N x 1% + 85%).
The initial value of 90% is reverted to if a value outside of the setting
range is set.
Setting to determine whether to give priority to width or length when
selecting the optimum sheet when printing received data.
"0": Priority to data length
"1": Priority to data width
This sets the receivable document width in cases where "11 x 17 sheet"
is selected as the FAX printing paper.
"1": B4 (B4, A4) width
"0": A3 (A3, B4, A4) width
MX-FXX1 SIMULATIONS, FAX SOFTWARE SWITCH 5 – 43
Initial value
0 Output
0
0 Re-send
0 Disconnect with DCN
0 128KB
0 Save and output en
masse following
completion of reception
0
0
0 Permitted
0 90%
1
0
1
0 Priority to data length
0
0
0
0
0
0
0
0
1
0
1
0
0 A3 width
0
System
settings