Comtech EF Data SDM-309B Installation And Operation Manual page 186

SDM-309B Satellite Modem
Status Only:
Response:
*Note: This command is only valid when fast acquisition is enabled. See the "FAM_"
command definition.
4.2.10 Sweep Width Range
This command sets the overall travel of the sweep during acquisition. The sweep width
may be set in the range of 0Hz to 50000Hz.
Command:
Response:
Status Only:
Response:
*Note: This command is only valid when fast acquisition is enabled. See the "FAM_"
command definition.
4.2.11 Sweep Direction
This command sets the direction of the sweep travel. "+" sets incremental sweep while "-
" sets decremental sweep.
Command:
Response:
Status Only:
Response:
*Note: This command is only valid when fast acquisition is enabled. See the "FAM_"
command definition.
4.3 Interface Configuration Commands (Drop & Insert Interface)
4.3.1 Insert Clock (Internal/Reference/Insert/Satellite)
Command:
Response:
Status Only:
Response:
MN/U-SDM309B Rev. #
<add/SCF_"cr""lf"
>add/SCF_xnnnnn"cr""lf"]
<add/SWR_nnnnn"cr""lf"
>add/SWR_nnnnn"cr""lf"]
<add/SWR_"cr""lf"
>add/SWR_nnnnn"cr""lf"]
<add/SD_s"cr""lf"
>add/SD_s"cr""lf"]
<add/SD_"cr""lf"
>add/SD_s"cr""lf"]
s = + or - (direction of sweep travel during acquisition).
<add/IC_xxx"cr"
>add/IC_xxx"cr""lf"]
<add/IC_"cr"
>add/IC_xxx"cr""lf"]
(x = + or - sweep offset direction).
(nnnnn = 0 to 25000.
(nnnnn = 0 to 50000.)
(xxx = INT, REF, INS, or SAT)
Remote Control
B-B–9