Blackmagicdesign ATEM Television Studio Installation And Operation Manual page 40

Using ATEM Software Control
40
Set Video Standard
To change an input name, click in the text field, enter the text and select set. The input name will be updated
on the Multi View, software control panel and broadcast panel if one is connected. It's a very good idea to
change both the short and long labels at the same time, so they match. For example Camera 1 would be
entered in as a long label, and CAM1 as the short label.
Setting the Switcher Video Standard
The video setting is used to select the operating video standard of the ATEM switcher, and this must
be set to the same video standard as the video sources you are plugging into the ATEM switcher. If they
don't match, the inputs won't appear correctly, and will most likely remain black. A good way to work out
the video standard you should use is to check your cameras, and then set the switcher video standard to
the same format.
ATEM currently supports the following video standards:
ATEM Production Studio 4K Models
SD 525 59.94i NTSC
SD 625 50i PAL
SD widescreen anamorphic 525 59.94i 16:9
SD widescreen anamorphic 625 50i 16:9
HD 720 50p
HD 720 59.94p
HD 1080 50i
HD 1080 59.94i
HD 1080 23.98p
HD 1080 24p
HD 1080 25p
HD 1080 29.97p
HD 1080 50p
HD 1080 59.94p
Ultra HD 23.98p
Ultra HD 24p
Ultra HD 25p
Ultra HD 29.97p
ATEM Television Studio, 2 M/E Production
Switcher and 1 M/E Production Switcher
SD 525 59.94i NTSC
SD 625 50i PAL
SD widescreen anamorphic 525 59.94i 16:9
SD widescreen anamorphic 625 50i 16:9
HD 720 50p
HD 720 59.94p
HD 1080 50i
HD 1080 59.94i