Bypassing The Poc Test And Fluid System; Turning On The Fluid System When Idle; Turning On The Fluid System When Bypassed - Kodak VERSAMARK DS5110 Operator's Manual

Chapter 2. Basic Operation
Operating Procedures
2 - 6

Bypassing the POC Test and Fluid System

The printer can be turned on with the fluid system bypassed. Use this
method when the printer is to remain idle for more than 1 hour or during
troubleshooting.
To turn the printer on with the fluid system and POC test bypassed, press
and hold [OPEN EYELID]; press and release [PRINTER ON]. When all
lights on the operator panel come on, release [OPEN EYELID]. The
[PRINTER ON] light remains lit.

Turning On the Fluid System When Idle

To bring the fluid system out of idle, press [STANDBY]. The [STANDBY]
light flashes while the fluid system powers up and remains lit when the
fluid system is completely powered up. (See "Idle Time Guidelines" on
page 2-7.)

Turning On the Fluid System When Bypassed

To turn on the fluid system when it has been bypassed, press [CLEAN
PRINTHEAD]. The [CLEAN PRINTHEAD] light flashes during the
cleaning cycle and then goes off. The [STANDBY] light remains lit.
You may want to print a test pattern to ensure that print quality is
satisfactory (See Chapter 3, "Troubleshooting".)