Table of Contents
Advertisement
Display datum
1. Press CANCEL button until Chart Legend panel appears.
2. Place cursor over Details button and select.
3. Place cursor over WGS84 Shift and select.
4. The ARCS WGS84 Shift page opens, at the bottom is the box Output, this must be set to Chart WGS Shift.
5. This will apply the datum shift indicated by CHART SHIFT to the display and ensure the cursor and display is
operating on the same datum.
Define datum
This can only be used when WGS shift status is UNDEFINED or PARTIAL DEFINED.
1. Press and hold down CHART ALIGN button with the cursor over own ship.
2. With button still pressed move cursor to correct position and release CHART ALIGN button.
3. To reset datum to original values press Reset button.
Chart Management
Move chart
Place cursor in desired position of chart and press SET CHART CENTER in the Control Panel.
Chart type
1. Press CHART PLAN button in the Control Panel.
2. In the menu select
This system will automatically load charts as the operators zooms in or out.
Open ARCS chart
1. Select Catalogue from the menu
2. The ARCS catalog window will open containing the box View Filters.
3. Select required settings from the box View Filters:
Insets
Names
All Charts
Permit Charts
Group Charts
4. Select scale required as Planing, Ocean, Coastal, Approach, Harbour.
5. The different colour boarders indicate the following:
Green
Magenta
Red
6. Place the cursor on the boarder of the required chart and select
7. Information about the chart will appear in the Selected Chart box
8. Preview allows the chart to be viewed in a small scale
9. Open opens the selected chart
Open known chart
1. Press CHART PLAN and select from the menu Open
2. Select Manual from the sub menu, ARCS Open box appears
3. Select required chart from the list with the cursor
4. Press Open to open chart
Activate S57 chart
Activate ARCS chart
Displays insets (plans) included in charts
Displays chart numbers
Display limits of all available ARCS charts
Display limits of all charts with permits
Display limits of user defined group charts
available for use
chart not loaded but permit available
chart not loaded and no permit is available
for vector chart
for raster chart
Abridged Operator Instructions • • • • 15
Advertisement
Table of Contents
