Enabling/Disabling Networked Devices - EMS FirePoint System 5000 User Manual

EMS SYSTEM 5000

9.8 Enabling/Disabling Networked Devices:

Turn the control key switch to the "ON" position. Press "0" key to enter the "Options"
Menu. Press the ∇ key three times until the screen displays:" >Fire System Opts<".
Press the "YES" key and the screen will change to highlight ">Dev.Disable/Test<".
Press ∇ key once to highlight the option "> Net. Disable /Test<" and press the "YES" key
and the screen will now display:
NOTE: It is important the correct Panel type is highlighted.
PAN = Hardwired Panels. NET = Radio Network Panels.
This information can be provided by installer/Maintenance Contractor if required.
Press "YES" key once to change the Panel type to the required setting.
Press the ∇ key one time and the screen will now be highlighting, ">Panel : 00<".
Press the "YES" key to change the panel number until the desired panel number is
shown: Press ∇ key one time and the screen will change to highlight, " >Device : 00<".
Press "0" key and the screen will now display:
Enter the device number that you want to Enable/Disable e.g. 007, then press "YES" key
and screen will now display:
Press the ∇ key one time and the screen will change to highlight ">Status : Active<".
Press "YES" key once to change the Status of the device to Active or Disabled as desired.
Now press the ∇ key once and whilst highlighting ">Transmit Event<", press the "YES"
key to transmit the event. The screen will state that the change has been made.
Press "NO" key four times until the screen returns to the main display. Turn the control
keyswitch to the "OFF" Position and the screen will now indicate that the Status is
Normal.
| * Network Status *
> Panel Type : PAN
| Panel : 00
Yes = Select
Enter Device
(Number 1 - 256)
Number > _
Yes = Finish
| Panel :
>Device :
| Status : Active
Yes = Select
|
<
|
Time
Time
04 |
007 <
|
Time
USER MANUAL, ISSUE 2.4 – 19/11/09
21