Isolated Position Functionality - EMS FirePoint System 5000 User Manual

EMS SYSTEM 5000

6.3 ISOLATED Position Functionality:

The Control Panel requires the control keyswitch turned to the
ISOLATED position. Access Level 2 is accessible with the same
Features as detailed previously and all control buttons are operational.
Plant Shutdown equipment can be disabled through this function as a
pre selected Sounder Group can be disabled. This is normally used for
isolating Plant Equipment whilst carrying out weekly tests. However,
this is a programmable feature and can be configured by the installer/
maintenance contractor if required.
Scroll Buttons
Reset/Led
Test
Silence Alarms
Sound Alarms
View Tests
View
Disablements
View Faults
View Fires
Status Lamps,
(see fig 2)
System Menus
Isolated Lamp
nd
2 Feature
of key
nd
2 Feature
of key
nd
2 Feature
of key
nd
2 Feature
of key
N/A
N/A
ISOLATED
Operational when
displayed to enable each event to be
viewed.
This button has two functions. It is firstly
used to reset a Fire/Fault Event, after the
"Silence Alarm" button has been pressed
and the Fire/Fault Condition has been
cleared. It is secondly used to test all of the
Systems Status Lamps. This is achieved by
pressing the button when the Systems
Status is normal, i.e. no events displayed.
This button Silences the System's Sounders
and internal buzzers. The panel will give an
intermittent beep every 10 – 15 seconds
until the condition is reset and will display
Silence Alarms when pressed.
This key is used for activating the System's
Sounders. The display will show Alarms
Sounded when pressed.
Displays any device/zone currently in test.
This will automatically timeout and return
to the front screen if left in this mode.
Displays any device/zone
disabled. This will automatically timeout
and return to the front screen if left in this
mode.
Displays any device
condition. This will automatically timeout
and return to the front screen if left in this
mode.
Returns to view fire events if any of the
other view options
automatically timeout and return to the
Front screen if left in this mode.
Indicates the systems current status
Options and further Fire system Options
Menus are now accessible by pressing the
"0" Key. Details are shown in Section 7.
Sounder group disabled by key position.
This is a programmable feature normally
used for isolating plant equipment on a
weekly test and is configured by the
Installer/Maintenance contractor.
USER MANUAL, ISSUE 2.4 – 19/11/09
multiple events are
currently
currently in fault
used. This will
9