Fault : Bt: Mn; Fault :Bt; Fault :Pr - EMS FirePoint System 5000 User Manual

EMS SYSTEM 5000
The above display, tells us that device 56, has entered a Fault condition in Zone 4.
8.4 Fault : MN:
In the instance of a system mains failure, the controller will switch into battery safe
mode. This will turn the display completely off, and the "Power" LED will extinguish.
Pressing any key on the panel will re-activate the display and the following fault screen
will be shown: -
01 FAULT TOT 01
CONTROL PANEL
FAULT : MN 12:00
FAULT MN represents the controller has had a mains failure.
The "CIE Fault" LED will also illuminate when the above screen is displayed.
8.45 Fault : BT:
This fault can be displayed for a number of reasons. There maybe no batteries present in
the unit. Secondly the batteries may not be charging. Thirdly the battery voltage may be
low. The battery not charging and low voltage readings would be displayed after the
daily check at midday. The fault would be displayed immediately when batteries are not
present. For any of these instances the following screen would be displayed: -
01 FAULT TOT 01
CONTROL PANEL

FAULT :BT

12:00
8.5 Fault : PR:
Whenever the control panel's internal processor is reset, (including initial power up), the
following fault screen will be shown: -
01 FAULT TOT 01
CONTROL PANEL

FAULT :PR

12:00
USER MANUAL, ISSUE 2.4 – 19/11/09
14