EMS FirePoint System 5000 User Manual page 11

EMS SYSTEM 5000
(A) Options:
FUNCTION
Passwords
Time and Date
Logging
Fire System Options
(B) Fire System:
FUNCTION
Dev. Disable/Test
Net. Disable/Test
Det Zone Dis/Test
Alarm Zone Disable
ARE Disable
System Mode
Engineers Config
Printer Options
Contains 7 sub menus. This allows the option to change,
edit and delete PIN numbers if used.
Gives the option to set and view the Time and Date.
Enables you to view the entire log of events, (up to 1000
events), or to view the log at a certain date.
Allows access to (B) Fire System.
This option enables an individual device that forms part
of the fire system to be Disabled, Activated or put into
Test. The status lamps will illuminate/extinguish as
appropriate.
This option enables the user to control individual devices
that are logged onto other control panel's on the
Networked Fire System. Such as a smoke detector or call
point to be changed from their normal active status, to
be disabled or put into test.
This option allows the Detection Zone to be viewed and
altered. The zone can be either Active, Test or Disable. If
any zones on the system are disabled or in test mode the
relevant LED Indicators will light to indicate this.
This option allows the disablement of groups of sounders
within the system. The Alarm Zone can be either Enabled
or Disabled. If Disabled the relevant LED indicator will
illuminate.
This option allows connection to the Fire Brigade via the
Brigade Relay to be disabled. Therefore any subsequent
fire activation's will not operate this relay.
operation, although unaffected, will display the text
"ARE/BRIGADE DISABLED" to ensure the system is not
left in this mode.
This option allows enablement of up to eight different
system modes of operation. These are pre-programmed
and can be
Installer/Maintenance Contractor.
This option when entered prompts for a PIN number to be
entered to Allow access to Level 3. This menu is for
Installer/Maintenance Contractor use only.
This option allows the Printer, when fitted, to be both
"Enabled" and "Disabled".
option is set to ALL, every Event is printed out. This
option can also be set to FIRE, which will then only print
Fire Events.
DESCRIPTION
DESCRIPTION
changed if required
When "Enabled" and the
USER MANUAL, ISSUE 2.4 – 19/11/09
The panel
by the
11