ADEMCO Vista-20 User Manual page 21

BYPASSING PROTECTION ZONES
Using the ~ This key is used when you want to arm your system with one or more zones
BYPASS Key
intentionally unprotected. Bypassed zones are unprotected and will not cause an alarm
when violated while your system is armed. All bypasses are removed when an OFF
sequence (security code plus OFF) is performed. Bypasses are also removed if the
arming procedure that follows the bypass command is not successful.
The system will not allow fire zones to be bypassed.
To
bypass zones, the system must be disarmed first.
BYPASS
I.
nnn+m
ENTER SECURITY
CODE THEN PRESS BYPASS
(security code)
Example: PI ~] ~~ PI then press the BYPASS key.
2. n
ENTER
ZONE NUMBERS
(Zone Numbers)
Enter the zone number(s) for the zones to be bypassed
(e.g., 01,02,03, etc.).
Important! All single-digit numbers must be preceded
by a zero (for example, enter 01 for zone 1).
3"= '"'T
The keypad will display the word BYPASS along with
Typical b ypassmessage
each bypassed zone number. Wait for these zones to
be displayed, to be sure that intended zones are
bypassed.-
= 'Ready message.
4" OISRR17ED 8!iPRS5
ARM AS USUAL
Arm the,$ystem as usual when the keypad displays the
(Continued)
-21-