Fire Protection - ADEMCO Vista-20 User Manual

SYSTEM OVERVIEW
Fire Protection
The fire protection portion of your security system (if used) is always active and will
sound an alarm if a fire condition is detected. Refer to the FIRE ALARM SYSTEM
section for important information concerning fire protection, smoke detectors and
planning emergency exit routes from the premises,
Alarms When an alarm occurs, both the keypad and external sounders will sound, and the
keypad will display the zone(s) causing the alarm. If your system is connected to a
central monitoring station, an alarm message will also be sent, To stop the alarm
sounding, simply disarm the system.
Memory of Alarm When an alarm condition occurs, the keypad displays the number(s) of the zone(s) that
caused the problem, and displays the type of alarm (ex. FIRE, ALARM). It remains
displayed until it is cleared by disarming the system (see DISARMING THE SYSTEM
section).
Phone Access & Your system may include a voice module that will permit you to access the system via
Voice a Touch-tone phone, either on-premises or by call-in when away. The phone access
Response
feature will enable you to do the following:
CapabiliW Receive synthesized voice messages over the telephone regarding the status of the
security system.
Arm and disarm the system and perform most function commands via the telephone,
with voice confirmation provided after each command entry.
Complete information regarding the use of this feature is provided in a separate
manual entitled PHONE ACCESS USER'S GUIDE, which accompanies the voice
module.
-6-