Table of Contents
Advertisement
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
A-2 Specifications
* Input Power and Heat Dissipation specifications are maximum values and
apply to worst-case conditions at full rated power supply load. The power/heat
dissipation for your installation will vary depending on the equipment
configuration.
Power Cord Set Requirements
The power cord set (appliance coupler, flexible cord, and wall plug) supplied
with your ProLiant Storage System meets the requirements for use in the
country where you purchased your equipment.Power cord sets for use in other
countries must meet the requirements of the country where you use the
ProLiant Storage System. For more information on power cord set
requirements, contact your Authorized Compaq Dealer.
General Requirements
The requirements listed below are applicable to all countries:
1.
2.
3.
4.
The length of the power cord set must be at least 6 feet (1.8 m) and a
maximum of 15 feet (3.0 m).
All power cord sets must be approved by an accredited agency
responsible for evaluation in the country where the power cord set will
be used.
The power cord set must have a minimum current capacity of 10A and a
nominal voltage rating of 125 or 250 volts AC, as required by each
country's power system.
The appliance coupler must meet the mechanical configuration of an EN
60 320/IEC 320 Standard Sheet C13 connector, for mating with
appliance inlet on the storage system.
Advertisement
Table of Contents
