Engine Does Not Stop When The Alarm Sounds; Engine Does Not Stop When The Alarm Sounds Troubleshooting Flow Chart; Engine Does Not Stop When The Alarm Sounds Detailed Troubleshooting; Engine Does Not Stop When The Panic Signal Is Received - Honda 2007 CR-V Service Manual

Honda Remote Control Starter System Service Manual: 2007 CR-V
3. Connect the tablet tester to the under
dash data link connector. Then turn
on the ignition switch to communicate
with the HDS.
4. Under Honda System, Body
Electrical, Remote Control Engine
Starter, check if B2263 is shown.
Is B2263 shown?
YES – See section 9.2.11 for DTC
trouble shooting.
NO – Replace the control unit.

16.0 Engine Does not Stop When the Alarm Sounds

For security purposes when the alarm sounds the remote engine starter is designed to stop. If
the alarm doesn't stop the following diagnostic can be used to repair the vehicle.
16.1 Engine Does not Stop When the Alarm Sounds Troubleshooting Flow
Chart
Stop the engine
Check for security alarm
function/Panic alarm function.
Does it work Properly?
YES
Replace the control Unit
16.2 Engine Does not Stop When the Alarm sounds Detailed
Troubleshooting
16.2.1 Engine does not stop when the PANIC
signal is received
1. Stop the engine by another switch signal.
2. With the vehicle in range of the transmitter, press
and hold the PANIC button for 5 seconds
Does the Alarm Sound?
YES – Replace the control unit.
47
Table of Contents Table of Contents
NO
Refer to vehicle service
manual for repair.
PANIC