Engine Does Not Stop When A Stop Condition Has Been Met; Engine Does Not Stop Troubleshooting Flow Chart; Engine Does Not Stop Detailed Troubleshooting; Engine Does Not Stop When The Door Is Opened - Honda 2007 CR-V Service Manual

Honda Remote Control Starter System Service Manual: 2007 CR-V

15.0 Engine Does Not stop When a Stop Condition Has been met

When the engine is started with the remote controlled starter it is designed to stop under a
number of circumstances. See section 5.2. If the engine does not stop when one of the stop
conditions is met the following diagnostic information can be used.

15.1 Engine Does Not stop troubleshooting flow chart

Connect the HDS Tablet
Tester to the Data Link
Connector.
Check if any DTCs are shown.
Is DTC shown?
Refer to detailed trouble
shooting for repair
Stop Condition (Switch Signal)
Door Switch
Tailgate Switch
Ignition Key Switch
Brake Light Switch
Select Lever P Position Switch
Engine Revolution
Engine Hood Switch
Door Lock Knob Unlock Switch
Engine Low Oil Pressure Indicator
Engine Malfunction Indicator Lamp

15.2 Engine Does not Stop Detailed Troubleshooting

15.2.1 Engine does not stop when the
door is opened
1. Connect the tablet tester to the under
dash data link connector. Then turn
on the ignition switch to communicate
with the HDS.
2. Under Honda System, Body
Electrical, Remote Control Engine
Starter, check if B2255 is shown
Is B2255 shown?
43
Table of Contents Table of Contents
NO
Replace Control Unit
YES
DTC
B2255
B2256
B2256
B2256
B2257
B2258
B2259
B2262
B2263
B2263
Related Vehicle Control Unit
Multiplex Integrated Control Unit
Multiplex Integrated Control Unit
Multiplex Integrated Control Unit
Multiplex Integrated Control Unit
Gauge Control Module
Gauge Control Module
Multiplex Integrated Control Unit
Multiplex Integrated Control Unit
Gauge Control Module
Gauge Control Module