Solenoid Cut Relay/Power Window Cut Relay/Sunroof Cut Relay 1. Check That There Is Continuity Between Terminal 3 And; Shift Lock Solenoid Detailed Troubleshooting - Honda 2007 CR-V Service Manual

Honda Remote Control Starter System Service Manual: 2007 CR-V
18.2 Shift Lock Solenoid
Detailed Troubleshooting
1. Disconnect the blue 23 pin remote
starter connectors which go
between the original vehicle
connectors.
2. Connect the vehicle's original
connectors back together and make
sure the shift lock solenoid works
properly.
Does it work properly?
YES – Go to step 3
NO – Refer to the vehicle service
manual to repair the shift lock
solenoid.
3. Disconnect the connector from the
solenoid cut relay.
4. Apply 12V across the relay control
lines and check for relay function.
See section 23
Does the relay function properly?
YES – Go to step 5.
NO – Replace the relay.
5. Measure the voltage between the
Red lead and Body Ground.
Is there battery voltage?
YES – Go to step 6.
NO Repair the open circuit in the
Red lead between the 3A fuse and
relay.
6. Disconnect the connector from the
control unit.
7. Check for continuity in the Light
Green lead between the relay and
the control unit.
Is there continuity?
YES – Go to step 9.
NO – Repair the open circuit.
50
Table of Contents Table of Contents