System Basics; How To Start A Car With The Remote Transmitter; How To Stop The Engine Using The Remote Transmitter; Remote Controlled Engine Starter Function - Honda 2007 CR-V Service Manual

Honda Remote Control Starter System Service Manual: 2007 CR-V

2.0 System Basics

The system requires proper installation and registration before it will start. Please refer to the
installation instructions to install and register the remote control starter system.

2.1 How to Start a Car with the Remote Transmitter.

1. Place the vehicle in Park.
2. Remove the key from the ignition.
3. Close all doors including the hood and tailgate.
4. Lock all doors.
5. Press the "Command" button followed by the lock button.

2.2 How to Stop the Engine Using the Remote Transmitter

The engine will stop under numerous conditions (Section 3.5)
To stop the engine only:
1. Start the engine with the remote starter.
2. Press the command button followed by the unlock/stop button.

3.0 Remote Controlled Engine Starter Function

3.1 Construction

The Remote Control Starter System consists of a transmitter, antenna, control unit, wire harness
and related relays to control large amounts of current without having the large current flow inside
the control unit and wire harness.

3.2 Communication

After receiving the "Starter Signal" from the transmitter, the control unit checks if the
necessary requirements are met to turn on the starter motor by checking the vehicle's BCAN
line and the switched inputs to the remote starter control unit.

3.3 Conditions Required to Remote Start the Engine

The following conditions must be met to switch on the IG1 relay and the starter motor relay
which start the vehicle.
•
All doors are closed. (Door switches: Off)
•
Tailgate is closed. (Tailgate switch: Off)
•
Engine hood is closed. (Engine hood switch: Off)
•
Door locks are activated (Door lock knob unlock switch: Off)
•
Transmission select lever is in the P position. (P position switch: On)
•
Key is not inserted into the ignition: (Key switch: Off)
•
IGN 1 signal is not at 12V.
•
Brake pedal is not pressed. (Brake light switch: Off)
•
Security alarm signal is not ON.
•
System is not in PANIC condition.
6
Table of Contents
Unlock/stop
button
Command
Button
Lock/start
button